Libec Large rubber feet for T102RB, T103B, T103C, T150B, T150C and T150F

These heavy-duty pads are engineered to fit over the dual metal ground spikes of Libec's high-capacity broadcast and studio tripod lines, protecting internal flooring surfaces from scratches while preventing the tripod from sliding on slick surfaces.

Component Compatibility Overview

The FP-6B feet are designed specifically as an optional or replacement accessory for Libec’s heavy-duty aluminum and carbon fiber leg lines:

• T102RB: One-stage heavy-duty aluminum tripod legs.

• T103B & T103C: Two-stage heavy-duty aluminum (B) and carbon fiber (C) tripod legs.

• T150B & T150C: Heavy-duty one hundred and fifty millimeter bowl aluminum (B) and carbon fiber (C) legs.

• T150F: One hundred and fifty millimeter bowl flat-top studio tripod legs.

Core Features & Mechanics

• Secure Flip-Lock Mechanism: Unlike generic slip-on rubber caps that can easily pull loose or get left behind in mud and soft terrain, the FP-6B units use an integrated mechanical flip-lock latch. This mechanical clamp bites tightly onto the lower structural molding just above the tripod spikes, keeping them perfectly anchored.

• High Torsional Traction: The undersides of the pads feature a wide, segmented tread pattern. This surface layout increases physical traction on smooth production studio surfaces, polished concrete, stone, and gym floors.

• Mid-Level Spreader Alignment: These feet are explicitly intended to be used when you configure your tripod with a mid-level spreader (such as the BR-6B). Because a mid-level spreader lifts the lower stabilization struts off the ground, the FP-6B pads ensure the bare metal ground spikes do not touch or mar the floor surface.

Hardware Technical Specifications Matrix:

Operational System Tips for the FP-6B:

💡 The Floor Spreader Clean Swap: If your production shifts from an outdoor mid-level spreader configuration to a flat studio floor using a Libec SP-6B floor spreader, you must unlatch and remove the FP-6B rubber feet first. The SP-6B floor spreader features its own integrated socket anchors that lock directly onto the bare metal leg spikes. Storing the rubber feet inside your tripod transport bag ensures the spikes line up cleanly with the floor spreader locking pins.

• Preventing Lock Binding: When shooting outdoors on sandy or muddy terrain with the mid-level spreader active, sediment can sometimes pack into the flip-lock lever mechanism. Always give the mechanical latches a brief rinse with fresh water before snapping them completely shut to prevent grit from scouring the composite hinge pins over time.